Nortel Networks Nortel Secure Network Access Switch 4050 Manuel d'utilisateur télécharger pdf (Page 564)

100

101

564 Chapter 10 Configuring system settings

320818-A

2 Enter the RADIUS authentication information in the applicable fields.

Table 118 describes the Radius Audit Configuration fields.

3 Click Apply on the toolbar to send the current changes to the Nortel

SNAS 4050. Click Commit on the toolbar to save the changes permanently.

Table 118

Radius Authentication Configuration fields

Field Description

Server Timeout Specifies the timeout interval for a connection request to a

RADIUS server. At the end of the timeout period, if no

connection has been established, authentication will fail.

Enter a value to indicate the time interval in seconds (

s),

minutes (

m), or hours (h). If you do not specify a

measurement unit, seconds is assumed. The range is

1–10000 seconds. The default is 10 seconds.

Use Local Password as

Fallback

Specifies the desired fallback mode. Valid options are:

•

on — if the RADIUS servers are unreachable, the local

passwords defined on the Nortel SNAS 4050 are used

as fallback

•

off — if the RADIUS servers are unreachable, the

only way to access the system is to reinstall the

software (boot install)

When checked, the fallback mode is

on.

The default is on.

Note: With the fallback mode set to

on, unwanted access

to the Nortel SNAS 4050 is possible using a serial cable if

the network cable is disconnected and the local password

is known.

RADIUS Authentication

Enabled

When checked, enables RADIUS authentication of system

users. The default is disabled.

1 2 ... 559 560 561 562 563 564 565 566 567 568 569 ... 921 922

Commentaires sur ces manuels

Pas de commentaire

Nortel Networks Nortel Secure Network Access Switch 4050 Manuel d'utilisateur Page 564

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Nortel Networks Nortel Secure Network Access Switch 4050