Nortel Networks Nortel Secure Network Access Switch 4050 Manuel d'utilisateur télécharger pdf (Page 469)

100

101

Chapter 10 Configuring system settings 469

Nortel Secure Network Access Switch 4050 User Guide

Viewing host information

To view the host number and IP address for each Nortel SNAS 4050 device in the

cluster, use the

/cfg/sys/host <host ID>/cur command.

Configuring host interfaces using the CLI

The default IP interface on the Nortel SNAS 4050 host is Interface 1. You can

create additional interfaces and specify the ports to be assigned to each interface.

If you assign more than one port to an interface, you can choose whether the ports

will operate in failover or trunking mode.

You can create a maximum of four interfaces on each Nortel SNAS 4050 host.

To configure an IP interface and the assignment of physical ports on a particular

Nortel SNAS 4050 host, use the following command:

/cfg/sys/host <host ID>/interface <interface ID>

where interface ID is an integer in the range 1 to 252 that uniquely identifies

the interface on the Nortel SNAS 4050 host. To configure a new interface, enter an

unused interface ID number. To change the configuration of an existing interface,

enter the applicable interface ID number.

The Host Interface menu displays.

The Host Interface menu includes the following options:

/cfg/sys/host #/interface <interface ID>

followed by:

ip <IPaddr>

Sets the network address for the interface. (For

Interface 1, the network address is the RIP.)

netmask <mask>

Sets the subnet mask for the interface.

1 2 ... 464 465 466 467 468 469 470 471 472 473 474 ... 921 922

Commentaires sur ces manuels

Pas de commentaire

Nortel Networks Nortel Secure Network Access Switch 4050 Manuel d'utilisateur Page 469

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Nortel Networks Nortel Secure Network Access Switch 4050