Nortel Networks Nortel Secure Network Access Switch 4050 Manuel d'utilisateur télécharger pdf (Page 524)

524 Chapter 10 Configuring system settings

Adding interface ports

To add ports to the selected interface, perform the following steps:

1 Select the System > Hosts > host > interface > Port tab.

The Port screen appears (see Figure 142 on page 523).

2 Click Add.

The Add a Port dialog appears.

3 Enter the port information in the applicable fields. Table 102 describes the

Add a Port fields.

4 Click Add.

The new port appears in the Port Table.

5 Click Apply on the toolbar to send the current changes to the Nortel

SNAS 4050. Click Commit on the toolbar to save the changes permanently.

Removing interface ports

To remove ports assigned to an interface, perform the following steps:

1 Select the System > Hosts > host > interface > Port tab.

The Port screen appears (see Figure 142 on page 523).

2 Select the port from the Port Table.

3 Click Delete.

A confirmation dialog appears.

4 Click Yes.

Add a Port fields

Field Description

Port Number Specifies the port number of the physical port on the

Pas de commentaire

Nortel Networks Nortel Secure Network Access Switch 4050 Manuel d'utilisateur Page 524