Nortel Networks Nortel Secure Network Access Switch 4050 Manuel d'utilisateur télécharger pdf (Page 46)

100

101

46 Chapter 1 Overview

320818-A

Identify switch ports as either uplink or dynamic. When you configure the

uplink ports, you associate the NSNA VLANs with those ports. Clients

are connected on the dynamic ports. You can configure NSNA ports (both

dynamic and uplink) after NSNA is enabled globally.

l Enable NSNA globally.

For more information about configuring an Ethernet Routing Switch 5510,

5520, or 5530 in a Nortel SNA network, see Release Notes for Nortel Ethernet

Routing Switch 5500 Series, Software Release 4.3 (217468-B).

For more information about configuring an Ethernet Routing Switch 8300 in a

Nortel SNA network, see Release Notes for the Ethernet Routing Switch 8300,

Software Release 2.2.8 (316811-E).

For an example of the commands used to create a Nortel SNA configuration,

see “Configuration example” on page 779.

5 Perform the initial setup on the Nortel SNAS 4050 (see “Initial setup” on

page 52). Nortel recommends running the quick setup wizard during initial

setup, in order to create and configure basic settings for a fully functional

portal.

6 Enable SSH and SRS Admin to allow communication with the SREM (see

“Configuring administrative settings using the CLI” on page 483).

7 Generate and activate the SSH key for communication between the Nortel

SNAS 4050 and the network access devices (see “Managing SSH keys using

the CLI” on page 84 or “Managing SSH keys using the SREM” on page 102).

8 Specify the Software Requirement Set (SRS) rule for the default

tunnelguard group (see “Configuring groups using the CLI” on page 198

or “Configuring groups using the SREM” on page 208).

9 Add the network access devices and export the SSH key (see “Adding a

network access device using the CLI” on page 75 or “Adding a network

access device using the SREM” on page 91).

10 Specify the VLAN mappings (see “Mapping the VLANs using the CLI” on

page 82 or “Mapping the VLANs using the SREM” on page 96).

11 Test NSNA connectivity by using the

/maint/chkcfg command in the CLI

(see “Performing maintenance using the CLI” on page 726) or checking the

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 921 922

Commentaires sur ces manuels

Pas de commentaire

Nortel Networks Nortel Secure Network Access Switch 4050 Manuel d'utilisateur Page 46

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Nortel Networks Nortel Secure Network Access Switch 4050