Nortel Networks Contivity1510D Manuel d'utilisateur télécharger pdf (Page 33)

Reference for the Contivity VPN Switch Command Line Interface

Chapter 1

Introduction

This chapter provides an introduction to the Contivity VPN Switch Command

Line Interface (CLI).

Accessing the CLI

Access from a Telnet session

You access the CLI by starting a Telnet session to the switch’s Management IP

Address, for example:

telnet 10.0.16.247

You then log into the switch using an account with administrator privileges, for

example:

Password: *******

Upon login, the CLI prompt appears (%%), indicating that you are in the CLI User

Exec Mode. You can execute any User Exec Mode commands or change the

command mode in order to execute other commands.

Note:

The Telnet protocol must be enabled on the switch in order to use

the CLI via a Telnet connection. Use the Services->Available screen to

enable the Telnet management protocol.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 221 222

Pas de commentaire

Nortel Networks Contivity1510D Manuel d'utilisateur Page 33