Nortel Networks Contivity1510D Manuel d'utilisateur télécharger pdf (Page 199)

Chapter 3 Bulk Load Command 199

Reference for the Contivity VPN Switch Command Line Interface

Add branch office connection

The ADD_CONNECTION command defines a branch office control connection

with specific attributes. The connection must contain authentication information

before it is created. Once a connection is created with the required attributes, it is

automatically enabled. This command has been modified for the Contivity VPN

Switch Version 3.0

COMMAND: ADD_CONNECTION

GROUP: [Group name]

NAME: [Connection name - Required]

SYSTEM_IP: [Contivity management IP address - Required for

Restricted tunnel]

LOCAL_ENDPOINT: [Local interface IP address - Required]

REMOTE_ENDPOINT: [Remote interface IP address - Required]

RESTRICTED: [Control Tunnel {True/False} - Default:False]

FILT_NAME: [Tunnel filter name - Required]

ROUTING: [Routing type {Static/Dynamic} - Default:Static]

TUNNEL: [Tunnel type {IPSEC,PPTP,L2TP} - Default:IPSEC]

// Static Routing

NET_NAME: [Local accessible network - Required for Static

Routing]

NAT_NAME: [NAT Translation (Optional for Static Routing)]

SUBNET: [Remote Accessible Net Subnet - Required for Static

Routing]

Note:

Using a SYSTEM _IP value other than the actual management IP

address, will create a NAT SET for the Management IP.

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 221 222

Pas de commentaire

Nortel Networks Contivity1510D Manuel d'utilisateur Page 199