Nortel Networks 10BASE-T Manuel d'utilisateur télécharger pdf (Page 153)

Using the Console Interface

309985-C Rev 00

3-11

BootP Disabled

Allows the switch to be managed only by using the IP address set from the

console terminal (this is the default mode for your switch).

When selected, this mode operates as follows:

• The switch does not broadcast BootP requests, regardless of whether an IP

address is set from the console terminal.

• The switch can be managed only by using the in-band IP address set from the

console terminal.

These actions take effect after the switch is reset or power cycled, even if an IP

address is not currently in use.

BootP or Last Address

Allows the switch to be managed even if a BootP server is not reachable.

When selected, this mode operates as follows:

• When the IP data is entered from the console terminal, the data becomes the

in-band address of the switch and BootP requests are not broadcast. The

switch can be managed using this in-band IP address.

• When the in-band IP address is not set from the console terminal, the switch

broadcasts BootP requests until it receives a BootP reply containing an

in-band IP address. If the switch does not receive a BootP reply that contains

an in-band IP address within 10 minutes, the switch uses the last in-band IP

address it received from a BootP server. This IP information is displayed in

the Last BootP column.

If an IP address is not currently in use, these actions take effect immediately. If an

IP address is currently in use, these actions take effect only after the switch is reset

or power cycled.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 329 330

Pas de commentaire

Nortel Networks 10BASE-T Manuel d'utilisateur Page 153