Nortel-networks Application Server 53r 5300 00 Manuel d'utilisateur télécharger pdf (Page 107)

Installing the firmware upgrades 107

Procedure Steps

Step Action

Load the hard drive firmware upgrade CD into the CD-ROM

drive.

2 Log on to the server as the SSA role (ntsysadm).

Reboot the server.

sudo reboot

If the operating system has been installed, change the boot

sequence so that the CD-ROM is the primary boot device by

doing the following:

•

When the BIOS information appears, press F12 to select the

boot sequence.

•

Select CD-ROM as the primary boot device.

Otherwise, wait for the server to reboot.

The ServeRAID Manager Hard Drive Update screen appears.

5 If an upgrade is required, press Enter to apply the upgrade.

The hard drive firmware upgrade is installed.

Otherwise, press Enter and go to step 7.

Select OK twice to complete the upgrade.

Attention: Do not power off the system during the upgrade.

When the update completes, remove the CD from the CD-ROM

drive and select OK to boot the operating system.

--End--

Installing ServeRAID ﬁrmware upgrades

Use this procedure to install ServeRAID firmware upgrades. This

procedure requires the reboot of the server.

Prerequisites

• You must be assigned to the SSA role (ntsysadm).

• You must have the CD containing the ServeRAID firmware upgrade

file.

Application Server 5300

Nortel AS 5300 Installation

NN42040-300 01.04

4 November 2008

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 123 124

Pas de commentaire

Nortel-networks Application Server 53r 5300 00 Manuel d'utilisateur Page 107