Nortel-networks Nortel Backbone Link Node Router 5030 Manuel d'utilisateur télécharger pdf (Page 9)

DSL Access Wiring

" Procedure

1. Attach new wiring to the T1/R1 connectors that will go to the DSL jack from the

punchdown block or NID.

2. Tighten the T1/R1 terminal screws with a flat-blade screwdriver.

97-15485

DSL

RJ11

Jack

Central

Office

Punchdown

Block or NID

Customer Premises

POTS/DSL

Local Loop

Demarcation Point

Twisted

Pair Wiring

POTS Splitter

You are now ready to run the specified wiring to the RTU location and install a DSL wall

jack. To install an RTU, refer to the

HotWire 5446 Remote Termination Unit (RTU)

Customer Premises Installation Instructions.

If the RTU is not being installed at this time, reconnect the local loop wiring at the

demarcation point.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Nortel-networks Nortel Backbone Link Node Router 5030 Manuel d'utilisateur Page 9