Nortel-networks Nortel Backbone Link Node Router 5030 Manuel d'utilisateur télécharger pdf (Page 3)

97-15247

POTS Splitter Housing

Mounting the POTS Splitter Housing

The POTS splitter can be placed:

H On the outside of the structure near the NID or punchdown block, or

H Inside the building.

When mounted outside, the POTS splitter must be installed at or above the height of

the NID, and should be a minimum of three feet above ground.

At the front of the housing, align the housing to open from the right with the rubber

grommet for cable access facing downward. Place the housing upright as shown. Use a

Phillips-head or combination Phillips/slotted-head screwdriver and the screws included

in the package.

If mounting to:

H Cement or cinder block: use a drill and

and 3/16″ masonry drill bit to install the

two plastic anchors first. Then, install the

two 8–15 x 1″ Type A screws.

H Wood: install only the two 8–15 x 1″

Type A screws and discard the

plastic anchors.

1 2 3 4 5 6 7 8 ... 11 12

Pas de commentaire

Nortel-networks Nortel Backbone Link Node Router 5030 Manuel d'utilisateur Page 3