Nortel Networks 210667-A Manuel d'utilisateur télécharger pdf (Page 8)

Network Connection

Locate connectors for Ethernet, antennas, and power on the back

of the AP. Ethernet configurations vary according to the

environment.

10BASE-T UTP

Use a 10BASE-T connection for multiple access points or an

access point attached to a wired UTP Ethernet hub or switch.

Normal 10BASE-T limitations apply.

To establish a 10BASE-T connection:

1 Plug the data cable RJ-45 connector into the access point

RJ-45 connector.

2 Plug the other end of the data cable into the LAN access port,

possibly a hub or wall connection.

3 Add additional access points as needed.

Note: The e-mobility site survey utility can be used to

determine the number of access points to install and their

locations.

Note: When connecting the e-mobility access point to an

Ethernet switch, ensure the switch port parameters are set

to 10 Mbps Half Duplex. Severe performance

degradation may result from mis-matched speed or

duplex modes.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Pas de commentaire

Nortel Networks 210667-A Manuel d'utilisateur Page 8