Nortel Networks AA1419005 Manuel d'utilisateur télécharger pdf (Page 9)

To install a CWDM GBIC in the switching module:

1 Remove the CWDM GBIC from its protective packaging.

2 Verify that the CWDM GBIC is the correct wavelength for

your network configuration (Table 1 on page 7).

3 Remove the dust cover from the CWDM GBIC’s optical

bores.

4 To prevent damage during handling, clean the ferrules of the

optical connector with an alcohol swab.

5 Grasp the CWDM GBIC between your thumb and forefinger.

6 Insert the CWDM GBIC into the slot on the front panel of the

Gigabit Ethernet switching module (Figure 3). A clicking

sound indicates it is properly seated.

The CWDM GBIC is installed.

For instructions about connecting the CWDM GBIC to a

multiplexer, see Installation and Networking Guidelines for

Optical Routing, part number 212257-A.

For instructions about monitoring communication between

the CWDM GBIC and the switch, see the user’s guide for the

switch.

Note: CWDM GBICs are keyed to prevent improper

insertion. If the CWDM GBIC resists pressure, do not

force it. Remove it, turn it over, and reinsert it.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Nortel Networks AA1419005 Manuel d'utilisateur Page 9