Nortel Networks CALLPILOT 555-7101-226 Manuel d'utilisateur télécharger pdf (Page 55)

November 2005 Installing the server and connecting the peripheral devices

Part 2: 703t Server Hardware Installation 55

To connect the mouse, keyboard, and monitor to the server

1 Place the monitor, keyboard, and mouse in the same location as the

server.

2 Plug the keyboard and mouse into the appropriate PS/2 connectors on

the chassis rear panel. See the diagram on page 54.

3 Plug in the monitor connector. Tighten the screws on the connector.

4 Connect the power cord to the monitor, and plug the other end into a wall

receptacle or power bar.

5 Turn on the monitor.

To connect the modem to the server

1 Ensure that the modem’s AC power cord is not plugged in.

2 Connect the large 25-pin male connector to the back of the modem.

Tighten the connector screws.

3 Connect the 9-pin female connector to COM1 port at the rear of the

server. Tighten the connector screws.

4 Connect one end of the telephone cable to the modem RJ-11 jack

labeled LINE.

5 Connect the other end of the telephone cable to the RJ-11 jack in the

wall.

6 Connect the power cord to the modem, and plug the other end into a wall

receptacle or power bar.

7 Turn on the modem.

What’s next?

Continue with “Connecting the server to the ELAN” on page 57.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 71 72

Pas de commentaire

Nortel Networks CALLPILOT 555-7101-226 Manuel d'utilisateur Page 55