Nortel-networks Control Clamp EMC Manuel d'utilisateur télécharger pdf

209823-A

June 2000

Installing the EMC Control Clamp

The EMC Control Clamp must be placed no further than 3.7 cm. (1-1/2 inches)

from the connector located on the PCMCIA card. The cable must pass through the

clamp three times to function properly.

To attach the EMC Control Clamp to the Ethernet cable, follow these procedures:

1. Open the clamp by placing your thumb

nail into the side of the clamp that has

the edge on it. Pull out and lift the top of

the clamp.

2. Place the Ethernet cable through the

center of the clamp. Adjust the cable to

make sure you are within 3.7 cm (1-1/2

inches) of the PC card connector.

3. Holding the cable in the clamp with your

thumb, wrap the Ethernet cable around

and through the center of the clamp two

more times.

4. Hold the Ethernet cable together in the

center of the clamp and close the clamp

until it snaps shut.

5. Connect the cable to the port on the

PCMCIA card.

1 2

Résumé du contenu

Page 1 - June 2000

209823-AJune 2000Installing the EMC Control ClampThe EMC Control Clamp must be placed no further than 3.7 cm. (1-1/2 inches) from the connector locate

Page 2 - '5F

'5F

Commentaires sur ces manuels

Pas de commentaire

Nortel-networks Control Clamp EMC Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Nortel-networks Control Clamp EMC. Nortel Networks Control Clamp EMC User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Nortel-networks Control Clamp EMC