Nortel Networks Nortel Secure Router 2330 Manuel d'utilisateur télécharger pdf (Page 37)

cac

max-calls ethernet0/1 256

10. Configure the CAC exclusion pool that identifies the IP address range of the SIP

endpoints that use SSM:

exclude-pool 100.20.47.0 255.255.255.0

exit cac

11. Point the SSM to the SIP Media Gateway IP interface as the default gateway

(specifying the non-default port), Port should be same as configured for gateway’s

listening port in step 3.:

default-gateway ipv4:100.20.42.80:5070 transport udp

exit ssm

exit voip

12. Configure the outbound proxy on the SIP Media Gateway to point to the SSM:

sip-ua

outbound-proxy ipv4:100.20.42.80:5060

13. Configure the primary and secondary SPS for the SIP Media Gateway:

(No need to configure secondary sip-server if there is only one SPS used):

sip-server ipv4:100.20.42.77:5060

sip-server ipv4:100.20.42.82:5060 secondary

14. Configure authentication parameters to be used for gateway to SPS calls and

registration:

authentication SR 4134 1234

15. Configure keepalive to monitor primary and secondary SPS connectivity:

keepalive target sip-server

keepalive target sip-server secondary

16. Configure dynamic registration from SR gateway to active SPS.

exit sip-ua

17. Configure voice ports for FXS phones

(example for 2 FXS phones connected to port 2/1 and 2/2)

voice-port 2/1

signal loop-start

station number 74001

1 2 ... 32 33 34 35 36 37 38 39 40

Pas de commentaire

Nortel Networks Nortel Secure Router 2330 Manuel d'utilisateur Page 37